FRU Removals and Replacements
Follow the numerical sequence in the FRU removal
sequence list and the exploded view to remove or
disconnect parts in the correct order. The letters in
parentheses in the list indicate screw types. See the
“Screw Size Chart” on page 19 to match the letters to the
correct screw type and size before replacing each screw.
Safety Notice 8: Translation on page 13
Before removing any FRU, power-off the computer,
unplug all power cords from electrical outlets, remove
the battery pack, then disconnect any interconnecting
cables.
Safety Notice 1: Translation on page 7
Before the computer is powered-on after FRU
replacement, make sure all screws, springs, or other
small parts are in place and are not left loose inside
the computer. Verify this by shaking the computer
and listening for rattling sounds. Metallic parts or
metal flakes can cause electrical shorts.
.1/
Battery Pack
.2/
Three Screw Covers and Three Screws (C)
.3/
Loosen Keyboard Assembly
(Raise front until it clears case.)
.4/
Two Ribbon Cables and Keyboard
(Slide keyboard forward and flip it over in front of
computer.)
.5/
Three Top Cover Screws (C)
(Inside right and left rear access doors along top
edge)
.6/
Two Status Display Ribbon Cables
.7/
Top Cover
(Use small screwdriver to release latch on left side,
if necessary.)
.8/
Two Status Display Screws (F)
(One on each end)
.9/
Status Display Assembly
(contains on/off and power saver switches)
.1ð/
Four Hinge Screws (C)
(Two on each end, inside two rear access doors)
.11/
Left Hinge Cables
.12/
Right Hinge Cables
.13/
LCD Assembly
.14/
Memory Modules
(Do not install two 4MB memory module kits. Install
a 2MB memory module kit in connector 1 and a
4MB or 8MB memory module kit in connector 2.)
.15/
Two Screws (F)
(At front edge of diskette drive)
Model L40 SX (8543)
39