IBM 6656-HG2, Service Manual

Page: 4 / 34

- 4 -
To obtain the correct cables and/or to get further instructions on installing them, call the IBM
HELPCENTER at the above numbers or contact your dealer, retailer, or other IBM authorized Servicer.
Alternative mounting options for your IBM Flat Panel Monitor may be available from specialist suppliers.
To attach the monitor to an arm or a surface of wall, please follow the instructions below:
1. Power off the monitor.
2. Fold the monitor arm in the order of Figure (A), (B) and (C) as shown above.
3. Place the monitor on a stable and shock-resistant floor, with the front of the monitor at the bottom.
4. Hold the metal clip and push it carefully until it clamps both of the stand and the arm firmly, as shown in
Figure (D) above. (The metal clip is used to keep the arm folded.)
5. You have to use the four screw holds on the bottom of the stand to attach the monitor to the surface of
wall. For additional information, see the instructions supplied with the purchased arm.
6. Locate a place to which you want to attach the monitor. When locating the place, you have to consider
the lengths of the signal cable and the power cord.
7. Attach the monitor to the place you selected in the step 6, and then reconnect the signal cable and the
power cord to the monitor.
(A) (B) (C)
( )
Metal clip
Screw holds
VESA Wall Mounting