IBM 6400-i05, Setup Manual

Page: 276 / 370

276
Chapter 6
Fault Messages
5. If the fault message reappears, power off the printer, wait 15 seconds,
then power on the printer.
6. Run your print job again. If the fault message reappears, turn off power to
the printer, then call your IBM service representative. Otherwise, no
further attention is required.
The following table explains each fault message and offers suggestions for
correcting the fault condition.
Table 12: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution
XXX 48 VOLTS CIRCUIT
FAILED
SEE SETUP GUIDE
No The power supply is not
generating a proper 48
volts or the CMX board
is not properly detecting
a 48 volt output. Contact your IBM service
representative.
001 END OF FORMS
LOAD FORMS
Yes Printer is out of paper. Load paper according to
instructions on page 66.
002 FORMS JAMMED
CLEAR JAM AND RELOAD
FORMS
Yes No paper motion. Clear paper jam and reload
paper. See the Operator’s
Guide. Reset forms
thickness lever.
003 FORMS EJECTED
PRESS EJECT/RESTORE
Yes Non–error status
message. Press Eject/Restore key
to return paper to print
position.
004 VIEW FORMS
PRESS VIEW KEY
Yes Non–error status
message. Press View key to return
paper to print position.
006 HOST SYSTEM
REQUEST ATTENTION Yes Host attention message. The host computer or
printer controller requires
attention.
007 FM HEADER ERROR No Format header error.
Applications software
has violated format
header parameters. Contact your system
administrator.
008 HOLD PRINT TIMEOUT
PRESS START
Yes Printer was off–line more
than 10 minutes and the
“Intervention Required”
parameter is set to
“Send to Host.” Press Start to put printer in
READY state.