IBM 621410U - IntelliStation E - Pro 6214, Hardware Maintenance Manual

Page: 109 / 176

a. Detach the fan sink cable.
b. Loosen the two captive screws on either side (in leaf spring enclosures) of
the fansink.
c.
With the two captive screws loosened, pivot the leaf spring assemblies
outward and out of the notches on the fansink assembly.
d. Lift the fan sink up and out of the computer.
Note: It may be necessary to gently twist the fansink to loosen it from the
processor.
Important: Be careful when handling the adhesive material on the
processor. If the adhesive material on the processor will be
reused, do not contaminate it. If replacement adhesive material
is provided with the replacement part, be sure to remove all
traces of existing adhesive material from the processor before
applying the new adhesive material.
6. Free the processor from the system board by rotating the processor socket lever
arm upward to its maximum vertical position.
7.
Lift the processor up and out of the computer.
8. To install a processor, reverse the previous steps.
Note: When reconnecting the fansink cable to the system board, be sure to
connect the cable to the connector marked
″
CPU fan
″
.
Speaker
To remove the speaker, do the following:
Note: Read “Before you begin” on page 41 and the safety notices at “Safety notices
(multi-lingual translations)” on page 135.
1.
Power-off the computer and remove external cables.
2. Remove the cover and support bracket (see “Side cover removal” on page 63
and “Support bracket removal” on page 64).
FRU information (service only)
101