© Copyright IBM Corporation 2019, 2020, 2021 Customer Install Guide, 1U Chassis
27
Install the enclosure on the slide rails
Note:
This unit weighs approximately 49lb (22kg). IBM recommends the use of an
appropriate lifting device to position the chassis on the rails.
Installing the System in a Rack
Pull the inner slide rails out of the rack until they lock into place (
1
). Locate the rear rail standoff
on each side of the system and lower them into the rear J-slots on the slide assemblies (
2
).
Rotate the system downward until all the rail standoffs are seated in the J-slots (
3
). Push the
system inward until the lock levers click into place. Press the slide-release lock buttons on both
rails and slide the system into the rack (
4
).
Figure 9. Enclosure Installation
Attention:
You can only install the enclosure successfully when the slides are
fully extended.