Installation and setup instructions
Use these instructions to install and set up your N7x50T series gateway.
Unpacking the N7x50T series gateway
Use these instructions to unpack the N7x50T series gateway.
Each N7x50T series system enclosure ships with an accessories kit and set-up kit bag containing
documentation and hardware parts for installing your system. The quantity of hardware parts is
determined by your system configuration and requirements.
Each shipment container includes the following contents:
v
N7x50T series system enclosure
v
N7x50T series system bezel
v
N7x50T series Installation and Setup Instructions
v
Electrostatic discharge (ESD) wrist strap
v
Cables required for connections from your system to storage expansion units and for connections
between storage expansion units, if ordered
v
General information kit, containing warranty, safety, and environmental information
v
Software license
>55 kg (121.2 lb)
CAUTION:
The weight of this part or unit is more than 55 kg (121.2 lb). It takes specially
trained persons, a lifting device, or both to safely lift this part or unit. (C011)
1.
Remove the foam hardware protectors and the plastic surrounding the system.
2.
Remove the storage system using the integrated handles attached to the sides of the storage system,
as shown in Figure 1 on page 2. Place the storage system on a table.
© Copyright IBM Corp. 2013
1
