IBM 2283, Hardware Maintenance Service

Page: 92 / 213

60 IBM Desktop System HMM
Factory-Installed Modem Card
NOTE: The factory-installed modem is a 56.6 Kbps
modem with a cable of microphone-in and
speaker-out from system board.
001 - START
•
In Windows XP or Windows 2000 Device Manager,
ensure that the modem is not configured with a
conflicting COM port and IRQ setting.
•
Ensure that the communication software is
configured with the correct COM and IRQ settings
(same COM port and IRQ as the modem).
•
Ensure that all communication parameters (baud
rate, data, stop and parity bits) are properly
configured and are identical on both sides.
•
Connect the phone line to the LINE port of the
modem card.
•
Power off the system unit.
NOTE: Check the outside phone line by connecting a
working telephone to the telephone wall jack.
Listen for a dial tone to ensure that the phone
line is good.
002 -
•
Power on the system unit.
•
Run the Diagnostics program from the service
partition.
•
Select All Tests, then execute Modem test.
003 - DOES THE MODEM PASS THE TEST? (YES,
READ AHEAD. NO, GO TO STEP 004.)
•
Power off the system unit.
•
Remove all adapter cards.
•
Connect a hard disk drive with pre-loaded
Windows XP, Windows 2000, or the other
operating system.
•
Power on the system unit.
•
Perform the following steps under Windows XP,
Windows 2000.
NOTE: If an operating system other than Microsoft
Windows XP or Windows 2000 is installed, the