IBM 2283, Hardware Maintenance Service

Page: 37 / 213

General Information 5
Power Management
•
Support ACPI (Advanced Configuration and Power
Interface) power management.
•
ACPI v1.0b and APM v1.2 compliant
•
CPU clock throttling and clock stop control for
complete ACPI S3 state support
•
PCI bus clock run, Power Management enable
(PME) control, PCI/CPU color generator stop
control.
•
Power-on Switch must support Soft-Off and
Full-Off.
- Touch for 1 second or less to put system on
Suspend state.
- Touch and hold for 4 seconds to put system on
Full-Off state (Power Supply standby remains).
•
System enters standby mode if any of following
conditions are met:
- Execute standby from Windows 2000 and XP
Start menu
- Press system power button if it is set to act as
standby function
- System is idle and the standby timer set in the
Windows 2000 and XP Power Management
Property
elapses
•
8 bytes of BIOS scratch register
Power Supply
•
External power bricks (160W for 15” TFT models;
160W for 17” TFT models)
Internal Cabling-15” and 17” MTM model
•
One ribbon cable for hard disk drive and CD/DVD-
ROM drive
•
One ribbon cable for four rear USB ports and one
parallel port
•
One 4-wire cable for hard disk drive and CD/DVD-
ROM power
•
One 6-wire cable for system power
•
One 4-in audio cable