IBM 2145-4F2, Installation Manual

Page: 64 / 143

3
Battery plate
4
Front panel assembly
2145 UPS-1U power connector
2145 UPS-1U cable retention bracket
The 2145 UPS-1U cable retention bracket ensures that the power cable connection
between the 2145 UPS-1U and the SAN Volume Controller 2145-8F4 is stable. The
bracket must be installed after you install the 2145 UPS-1U in the rack. You can
attach the bracket by performing the following steps:
1. Install the power cable into the far-right power supply on the rear of the 2145
UPS-1U.
2. Remove the bracket and the two screws from the packaging. See Figure 22
3. Place the bracket over the power supply inlets on the right rear of the 2145
UPS-1U, so that the two screw holes line up.
4. Screw in the two screws on each end of the cable retention bracket. See
Figure 23 on page 35.
Ground
Live
Neutral
svc00201
Figure 22. The 2145 UPS-1U cable retention bracket hardware
34
IBM System Storage SAN Volume Controller: Installation Guide
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|