Compliance Notice
The equipment has been approved in accordance with Council Decision 1999/5/EC on radio equipment and
telecommunications terminal equipment and the mutual recognition of their conformity. This device is
telecommunications terminal equipment intended to be connected directly to the public telecommunications network
(PSTN). However, due to differences between the individual PSTNs provided in different countries, the approval
does not, of itself, give an unconditional assurance of successful operation on every PSTN network termination
point. In the event of problems, contact your equipment supplier in the first instance.
Network Compatibility Declaration
The manufacturer: Xircom Inc, 2300 Corporate Center Drive Thousand Oaks, California 91329 USA, declares its
awareness of the Advisory Notes contained in ETSI Guides EG 201 120 and EG 201 121, including any
amendments thereto, and indicates below the networks with which the product MPCI3A56G-100 is designed to
work and any notified networks with which there may be interworking difficulties.
These products are designed to work on PSTNs in the following countries: Austria, Belgium, Denmark, Finland,
France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Norway, Portugal, Spain, Sweden, Switzerland, The
Netherlands, United Kingdom. Use the Xircom country selection features of provide with your Xircom modem to
configure your modem for these countries.
New Zealand Telepermit Compliance Notes
General
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the
item complies with minimum conditions for connection to its network. It indicates no endorsement of the product
by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item will work
correctly in all respects with another item of Telepermitted equipment of a different make or model, nor does it
imply that any product is compatible with all of Telecom's network services.
Important Notice
Under power failure conditions, this telephone may not operate. Please ensure that a separate telephone, not
dependent on local power, is available for emergency use.
Some parameters required for compliance with Telecom's Telepermit requirements are dependent on the equipment
(PC) associated with this device. The associated equipment shall be set to operate within the following limits for
compliance with Telecom's Specification:
– There shall be no more than 10 call attempts to the same number in any 30 minute period for any single
manual call initiation, and
– The equipment shall go on-hook for a period of not less than 30 seconds between the end of one call
attempt and the beginning of the next attempt.
Where automatic calls are made to different numbers, the equipment shall go off-line for a period of not less
than 5 seconds between the end of one call attempt and the beginning of the next attempt.
When used in the automatic answer mode, the equipment shall be set to answer within 3 and 30 seconds of the
receipt of ringing. This can be achieved by setting the AT 0 register between 2 and 10.
44
Summary of Contents for 10/100 EtherJet
Page 1: ...IBM 10 100 EtherJet Mini PCI Adapter with 56K Modem User s Guide...
Page 4: ......
Page 6: ......
Page 10: ...x...