IBM 10/100 EtherJet CardBus Adapter, Installation And Planning Manual

Page: 24 / 64

2-2 10/100 EtherJet CardBus Adapter
Installing under Windows 95 and
Windows 98
1. With Windows running, insert the EtherJet CardBus Adapter
into the CardBus PC Card slot and connect cables as shown
in Chapter 1, “Hardware Installation.”
Plug and Play Installation (Versions 950b OSR2 and later)
2. If Windows 95 displays the New Hardware Found window, fol-
low the instructions on the screen to complete the installation.
No further steps are necessary.
If the New Hardware Found window does not appear, go to
step 3.
Notes:
1. If the New Hardware Found window appears, but the
EtherJet CardBus Adapter does not initialize or shows
conflicts in Device Manager, see Windows 95 and Win-
dows 98 Troubleshooting on page 2-3.
2. If you are installing on a Toshiba portable computer and
the New Hardware Found window does not appear, see
the Windows Help file HELPDOCS.HLP on the IBM
CD-ROM for instructions.
Manual Installation (Windows 95 versions 950 or 950a)
3. Click Start , select Settings, then click Control Panel .
4. In the
Control Panel
, double-click
Network
.
5. In the Network window, Configuration tab, click Add .
6. In the Select Network Component Type window, double-click
Adapter .
7. In the Select Network Adapter window, click Have Disk .
8. Insert the IBM CD-ROM.
9. Select path\ in the input box, where path\ is the drive contain-
ing the IBM CD-ROM and click OK .
10. Select IBM 10/100 EtherJet CardBus Adapter Manual
Load and click OK .
fcp1mst.book Page 2 Wednesday, June 2, 1999 4:02 PM