MANUAL - MHSPOT30-FX
3
3. DMX SET UP
Notice
: Be sure to follow figures two and three when making your own cables. Do not use the ground lug on the XLR
connector. Do not connect the cable’s shield conductor to the ground lug or allow the shield conductor to come in
contact with the XLR’s outer casing. Grounding the shield could cause a short circuit and erratic behavior.
Special Note:
Line Termination. When longer cable
runs are used, you may need to use a terminator on
the last unit to avoid erratic behavior. A terminator
is a 110-120 ohm 1/4W resistor which is connected
between pins 2 and 3 of a male XLR connector (DATA
+ and DATA -). This unit is inserted in the female XLR
connector of the last unit in your daisy chain to termi
-
nate the line. Using a cable terminator will decrease the
possibilities of erratic behavior.
4. DISPLAY MENU:
DMX Address Mode
Setting of the DMX address
: Press
MENU
to select
Addr
, press Enter to start setting. Use
the
UP
or
DOWN
keys to set the desired Address. Then press
Enter
to confirm.
DMX Channel Mode
Selection of the channel mode
: Press
MENU
to select
Chnd
. Press
Enter
to start setting
Select the channel mode via the
UP
or
DOWN
keys: successively 9CH and 11CH. Press Enter
again to confirm your selection.
9CH
: 9Channel mode
11CH
: 11Channel mode
Master/Slave Mode
Setting the Master-slave mode
: Press
MENU
to select
SLnd
. Then press
Enter
to start set-
ting.
MAST, SL1
will be displayed. Press
UP
or
DOWN
to choose Master or slave, then press
Enter again to confirm your selection.
MAST
: Choose the device as master
SL1
: Choose the device as slave
Auto or Music-controlled Mode
Select between Auto Or Sound-controlled Mode:
Press
MENU
to select
ShNd
. Press
Enter
to start setting.
Auto & SoUn
will be displayed. Choose
Auto
for auto running of the
unit. Choose
SoUn
and the unit will follow the rhythm of the music. Press
Enter
to confirm
your choice.
Sound Sensitivity
Adjustment of sound sensitivity
: Press
MENU
, select
SEns
and press
Enter
to start set-
ting. Use the
UP
and
Down
keys to adjust the sound sensitivity from 0-100. Press
Enter
to
confirm your choice.
Pan Reverse
This option is set to reverse the Pan direction. Press
MENU
, select
Pan
, press
Enter
to start
setting,
UP
and
Down
to select
no
or
Yes
, then press
Enter
to confirm your choice
Tilt Reverse
This option allows the user to reverse the Tilt direction: Press
MENU
, select
tiLt
, press
Enter
to start the setting. Use the
UP
and
Down
keys to select
no
or
Yes
, then press
Enter
to
confirm your choice.