© Copyright LOTRONIC 2012 VHF1 / VHF2
Page 4
1-
Antennae :
Unfold the antennas to their maximum length to get the best possible signal for each channel
2-
Power switch :
Use this button to switch the receiver on or off
3-
Power led :
When you switch the receiver on, this led lights up. That means the receiver is on.
4-
CH2 RF led :
This led lights on when you switch the MIC 2 handheld transmitter on. That means the wireless
transmission between receiver and transmitter is available. If you switch on the MIC 2 transmitter and the CH
2 RF led stays off, you must check if the transmitter and the receiver are set to the same frequency or check
the battery of transmitter..
5-
Volume control
: Use to adjust output signal level. (VHF1)
CH 2 Volume control
: Used to adjust CH2 output signal level. (Only VHF2)
6-
Squelch control :
When the wireless transmission is not good or if you have noise on receiver output when
the transmitter is off, please adjust the squelch control. Make a good average set. Squelch control to the
left = minimum range (but interference occurs). Squelch control to the right = maximum range.
7-
Output:
Connect this output to a mic input of your mixer .
8-
DC power supply input:
Connect on this socket the AC-DC power supply provided with the set.
9-
CH 1 Volume control
: Use to adjust CH1 output signal level. (Only VHF2)
10-
CH1 RF led:
This led lights on when you switch the MIC 1 handheld transmitter on. That means the wireless
transmission between receiver and transmitter is available. If you switch on the MIC 1 transmitter and the CH
1 RF led stay off, you must to check if the frequency is same on receiver and transmitter or check the battery
of transmitter. (Only VHF2)
DESCRIPTION HANDHELD TRANSMITTER
1-
Battery compartment:
Unscrew battery cover. Place the 9V battery. Respect the polarity. Then screw the
battery cover on again.
2-
ON/MUTE SWITCH :
This switch has three positions :
-
Off position: The transmitter is off.
-
Mute position: The transmitter is on but no sound is transmitted to the receiver.
-
On position: The transmitter is on and sound is transmitted to the receiver.
3-
Battery level:
This indicator shows the battery level. If the led flashes once and goes off, the battery level is
OK. If the led stays on, the battery is low. You must to replace the battery.
4-
Grill and cartridge
