5
USING YOUR WIRELESS IBIKE
At the Beginning of Each Ride
Set your iBike on your wireless mount. Make sure the iBike fully locks into position. Wake up
your iBike from sleep. The iBike performs an “Auto Cal Wind” calibration. CUP YOUR HAND
OVER THE WIND PORT during this calibration so that wind won’t strike the wind port.
TIP:
THE “CAL WIND” STEP CAN ALSO BE PERFORMED AT ANY TIME. ENTER
SETUP; “CAL WIND” APPEARS. CUP YOUR HAND OVER THE SENSOR, THEN CLICK
THE CENTER BUTTON. “DONE” FLASHES AND THE IBIKE EXITS SETUP.
After completing the “Cal Wind” step you’re ready to ride!
iBike Buttons
1)
Center button
: Click to alternate between bike computer (speed, distance/watts, trip time)
and Power Meter (speed, power, cadence/heart rate).
2)
Top arrow:
Avg/Max
. Click: average values. Click again: maximum values.
3)
Left arrow:
Trip Totals/Lap Timer
. Click: trip kilojoules (KJ), total vertical climbed. Click
again: Total odometer distance and time. Click again: % ride memory usage (100% is full).
Click again: total distance and time of all rides. Click again: aero and frictional drag. Optional
(from Racr setup): NP/IF/TSS measurements. Press-hold: Lap Marker and lap stats.
4)
Bottom arrow:
Wind/Hills/Auto-Hill
. Click: hill slope displayed continuously. Click again:
wind speed. Press-hold: Auto-Hill on-off.
5)
Right arrow: Environment/Fit Train
. Click: hill slope, wind speed, current elevation. Click
again: temperature, time. Click again: date, year. Press-hold: Fitness Training (see below) \
Trip Reset
1)
Press-hold center button. “
Trip reset
” appears.
Click center button to confirm reset.
2)
Trip Reset starts a new trip and zeroes trip distance, trip time, KJ, calories, vertical climbed,
Lap Timer, and all avg/max values. New ride file begins for transfer to PC/Mac.
Erase All Ride Data (iPro and iAero only)
1) Use iBike software to erase ride memory from your iBike. Consult iBike SW instructions.
2)
OR
, on your iBike go to Setup/Eras Data. Click center button, select “yes” with up arrow then
click center button. Wait until “Eras Data” returns.
Lap Timer
1)
Lap 1 begins automatically after a Trip Reset is performed.
2)
Press-hold left arrow to end current lap and start immediately a new lap.
3) With each left arrow press-hold, the iBike shows the lap number just completed, then average
speed, average watts, and time length of the just-ended lap. After a few seconds the main screen
returns.
4)
At the end of your ride, to reset Lap Timer to “Lap 1”, perform a Trip Reset.
5) Markers are placed in the ride file for each lap.
Fitness Test
1) Enter Setup, scroll with up arrow to
“User No”
. Click center button, use up arrow to select
“User Yes”
. Click center button to accept. Scroll to
“Fit Test”
.
2) Click center button. Previous test results are shown: W/KG score, 1-10 fitness rating. Click
center button to start new test.
