21
ENG
We recommend checking the outlet temperature regularly to ensure that it is
optimal and adjusting it when necessary.
When the minimum water level has been reached, check for leaks of any kind and, if
there are none, turn on the filtration pump to expel the air inside the loop and fill it
with water. To do this, see section 5.6. Filtration by setting the activation time to 0
so that it comes on immediately. Then, follow the instructions in that section to set
the desired filtration intervals.
It is not possible to start any loop until the minimum water level is reached (L1
sensor), so all functions on the control panel are disabled besides the spotlights
.
As with filtration, it is possible to turn on the massage system in order to fill the water
loop. To do this, press
.
We recommend inspecting all connections to check for any leaks after turning on
the loops and rechecking after 30 minutes of operation.
After performing these checks, complete the Warranty form that comes with the
product and return it to the manufacturer.
To
adjust the jet flow rate and open/close the flow of water, proceed as follows:
16
5.
INSTRUCTIONS FOR USE
5.1.
Precautions
SAFETY NOTES
•
Check the water temperature regularly. Do not use water at temperatures above
40ºC. The ideal temperature is 35-36ºC.
•
Set the hot tub to a lower temperature if you are going to use the hot tub for more
than 10-15 minutes.
Summary of Contents for Hotel Spa
Page 4: ...6 ...