iBell JS10-70, Operator'S Manual

Page: 15 / 17

14

Keep the tool clean . Never use water or chemical cleaners to
clean your tool. Wipe clean with a dry cloth. Your power tool
requires no additional lubrication.

Cleaning covers or guards; When accumulation of dust on the
cover looks excessive, loosen the clamp and remove the cover.
Wash off accumulation of dust inside the cover and wipe it and
reinstall. Cleaning the of blade should be done as well.

We recommend using the original package for covering the
product or suitable means to protect it against dust.
Before and after each use, check the product and accessories (or
attachments) for wear and damage.

Inspecting cutting blade; Check the cutting blade carefully for
cracks or damage before and after each use. Continuing to use a
dull blade may cause a dangerous kickback and/or motor
overload.

Inspecting the supply cord ; Do not pull or carry the tool by the
electric cord or allow its contact with edges, sharp elements,
rough surfaces, oil or chemicals that may damage its flexible and
insulating properties.

Inspecting carbon brushes; The motor employs carbon brushes
which are consumable parts. Keep the brushes clean so that they
move freely on the support. Replace when they wear down to an
extended limit since an excessively worn carbon brush results in
motor trouble. Use only identical carbon brushes.
Both carbon brushes should be replaced at the same time.

The accessories or attachments included with the tool are
recommended only for use with this product. The use of any
other accessories or attachments might present a risk of injury to
persons. Only use accessory or attachment for its stated purpose.
This product does not contain any parts that can be repaired
by the consumer.
Contact an authorised service centre or a
similarly qualified person to have it checked and repaired.
CLEANING AND STORAGE
MAINTENANCE AND REPAIR
IBL JS10-70