120-260E
|
1
Note
If converting from propane to natural gas, order the natural gas conversion parts kit (IBC Part # P-845) from
your authorized IBC distributor.
Use the propane gas conversion parts kit if the fuel source at the site uses propane and the appliance has been set up
(factory fire-tested) to operate with natural gas. Check the rating plate to see which fuel source the particular appliance
has been set up with.
Using this conversion kit, a qualified technician will need to:
1. Perform a fuel conversion.
2. Perform a combustion test.
3. Fill in the information required on the fuel conversion labels, and affix them to the appliance after the conversion is
completed.
Warning
This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer’s
instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in
these instructions is not followed exactly, a fire, an explosion or production of carbon monoxide may result
causing property damage, personal injury or loss of life.
The qualified service agency is responsible for the proper installation of this kit. The installation is not proper
and complete until the operation of the converted appliance is checked as specified in the manufacturer’s
instructions supplied with the kit.
The appliance will automatically de-rate the maximum input at a rate of approximately 2% per 1,000’ above 4,500’. The
gas valve's zero-governor will ensure that the gas-air mixture is not affected at altitude.
Included with the conversion kit:
1 x Orifice - marked 535 - IBC Part # 180-174
1 x O-ring - IBC Part # 150-175
1 x Rating Plate Fuel Overlay - IBC Part # 080-272A
1 x Gas Valve Conversion Label - IBC Part # 080-107B
1 x Installer Identification Label - IBC Part # 080-211A
SFC-199 - Fuel Conversion to Propane
(NG to LP) Kit P-844
