![background image](http://html1.mh-extra.com/html/ibase-technology/mb892/mb892_user-manual_3269759048.webp)
BIOS SETUP
44
MB892 User’s Manual
Phoenix - AwardBIOS CMOS Setup Utility
SuperIO Device
POWER ON Function
BUTTON ONLY
ITEM HELP
Hot Key Power ON
Ctrl-F1
Onboard FDC Controller
Enabled
Onboard Serial Port 1
3F8/IRQ4
Onboard Serial Port 2
2F8/IRQ3
UART Mode Select
Normal
RxD , TxD Active
Hi, Lo
IR Transmission Delay
Disabled
UR2 Duplex Mode
Half
Use IR Pins
IR-Rx2Tx2
Onboard Parallel Port
378/IRQ7
Parallel Port Mode
SPP
EPP Mode Select
EPP1.7
ECP Mode Use DMA
3
Menu Level >
Onboard Serial Port 3
3E8
Serial Port 3 Use IRQ
IRQ10
Onboard Serial Port 4
Disabled
Serial Port 4 Use IRQ
IRQ11
PWRON After PWR-Fail
Off
Onboard SATA chip Mode
This field, by default, is set to SATA.
OnChip Primary/Secondary PCI IDE
The integrated peripheral controller contains an IDE interface with
support for two IDE channels. Select
Enabled
to activate each channel
separately.
IDE Primary/Secondary Master/Slave PIO
These fields allow your system hard disk controller to work faster.
Rather than have the BIOS issue a series of commands that transfer to or
from the disk drive, PIO (Programmed Input/Output) allows the BIOS to
communicate with the controller and CPU directly.
The system supports five modes, numbered from 0 (default) to 4, which
primarily differ in timing. When Auto is selected, the BIOS will select
the best available mode.
IDE Primary/Secondary Master/Slave UDMA
These fields allow your system to improve disk I/O throughput to
33Mb/sec with the Ultra DMA/33 feature. The options are
Auto
and
Disabled
.
Summary of Contents for MB892
