ibaRackline-PC CAM/HD
Manual
Issue 1.1
9
4
Safety instructions
4.1
Designated use
The device may be used only for the following applications:
Machine test and commissioning of industrial systems
Measurement data logging and analysis
Applications of iba software products (ibaPDA, ibaLogic etc.)
4.2
Proper installation site
The device can be installed only according to manufacturer's specifications:
19“ cabinet
19“ rack line
Electric Shock!
Before opening the device disconnect it from the mains and pull out the mains plug from
the socket equipped with earth contact!
Never use the device with a damaged mains cable!
Before opening the device disconnect it from the mains by unplugging the mains cable
from the socket equipped with an earth contact and wait for several minutes until the
components have cooled down! This will prevent injuries due to the electric shock or
burns!
Connect the device to one supply voltage only according to specifications on the built-
in power supply unit!
Always use a socket equipped with earth contact! Use a terminal strip with overvoltage
protection or an uninterruptible power supply (UPS)!
Always connect the device to earthed power networks (TN-networks according to VDE
0100 Part 300 and IEC 60364-3)! The operation via ungrounded networks or networks
(IT networks) earthed via impedance is not permitted!
In case of faults, a defective device or a possible defect pull out the mains plug from the
socket equipped with earth contact!
Never put a damaged device into operation!
Pay attention to sharp edges in the housing!
Never switch off the device by means of the mains switch before you have shut down
the device.
Electrostatic discharge!
Touch the components only in electrostatically discharged state!
