Manual ibaPADU-8-O
8
Issue 1.9
4
System requirements
ibaLogic Soft PLC system, running on a computer equipped with ibaFOB output
card(s)
ibaPDA-V6
system,
running on a computer equipped with ibaFOB output card(s)
PLC and control systems, with ibaLink-SM-64-io or ibaLink-SM-128V-i-2o board
as sender/receiver plugged into the PLC
5
Mounting and dismounting
5.1
Mounting
Make sure the din-rail clip at the back of the device fits properly into the top edge of the
DIN-rail and then lightly press the device down – back into the DIN-rail. The device will
easily snap into the DIN-rail. After that, connect the power supply and all necessary
connectors.
5.2
Dismounting
First remove all connectors from the device.
With one hand press the top of the device slightly down to ensure that the device later
will be secure between both hands.
Place two fingers of the other hand under the bottom of the device and slightly push the
device upward. The device will easily remove from the DIN-rail.
