5
iArmor
®
Customer Support: [email protected]
Rev. 20200801
STEP 7
Once all (3) Brackets have been installed, attach the Assem-
bled Driver Side Step Bar to the Mounting Brackets using (6)
M6X1-20 T-Bolts, (6) M6 Flat Washers and (6) M6X1 Nylon
Lock Nuts
(Fig 10)
. Do not fully tighten hardware at this time.
STEP 8
Properly level and adjust the Step Bar and fully tighten all
hardware.
Models requiring drilling for driver side Support Brackets
:
a.
Make sure the Step Bar is level to the vehicle. Adjust and
tighten all mounting hardware.
b.
Line up the slots on the Support Brackets with the back of
the pinch weld. Mark the location of the slots onto the pinch
weld.
c.
Drill (2) 1/4” holes through the pinch weld for each Support
Bracket.
IMPORTANT
: Do not drill too close to the bottom
edge of the pinch weld. Adjust the Brackets as necessary to
move the slots up the body panel away from the edge. Drill the
holes toward the outside of the marked slots.
d.
Attach each Support Brackets to the pinch weld with (2)
M6X1-25 Hex Bolts, (4) M6 Large Flat Washers and (2) M6X1
Nylon Lock Nuts,
(Fig 7)
. Check for level then fully tighten all
hardware.
STEP 9
Move to the passenger side of the vehicle. Repeat
Steps 2-8
to install passenger side step bar.
NOTE
: All Mounting Brackets and Support Brackets for pas-
senger side are the same.
(6)M6X1-20 T-Bolts
(6)M6 Large Flat Washers
(6)M6X1 Nylon Lock Nuts
(Fig 10) Driver Side Step Bar Installed
Front
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
In order to protect your bars/boards, please use only mild soap/non-abrasive products for cleaning.
