3
Rev. 20221201
iArmor
®
Customer Support: [email protected]
STEP 2
Locate the Passenger Side mounting locations as shown on
(Fig 1).
Install M8 Clip-on Nuts to the rocker panel as shown
(Fig 2).
STEP 1
Install (4) Pedals onto the step bars with (24) M8X1.25-25mm
Hex Bolts, (24) M8 Large Flat Washers and (24) M8 Lock
Washers.
IMPORTANT:
Don’t punch the pedal with any metal hummer
within pedal installation, or the pedal will be damaged.
The instruction here is for your reference only. We strongly
recommend the professional installer for best result. We are
not responsible for any damage caused by the installation.
(6) M8X1.25-25 Hex Bolts
(6) M8 Large Flat Washers
(6) M8 Lock Washers
STEP 3
Start from the Passenger side front mounting location. Assem-
ble Passenger Front Mounting Bracket
(PFM/PRM)
and Pas-
senger Front Support Bracket
(PFS/PRS)
with (1) M8X1.25-
25mm Hex Bolt, (2) M8 Large Flat Washers and (1) M8 Nylon
Lock Nut,
(Fig 3).
Attach the assembled Passenger Front Mounting Bracket to
the installed M8 Clip Nut with (1) M8X1.25-25mm Hex Bolt, (1)
M8 Large Flat Washer, (1) M8 Lock Washer. Secure the lower
mounting hole on the bracket to the pinch weld with (1)
M10X1.5-25mm Hex Bolt, (2) M10 Flat Washers, (1) M10 Lock
Washer, (1) M10 Hex Nut. Do not fully tighten hardware at this
time,
(Fig 4).
(Fig 1) Passenger Side Mounting Locations
(Fig 3) Passenger Front Mounting Brackets Assembly
(Fig 2) M8 Clip Nut Installation
M8 Clip Nut
(1) M8X1.25-25mm Hex Bolt
(2) M8 Large Flat Washers
(1) M8 Nylon Lock Nut
PFM/PRM
PFS/PRS
