CV-M40
- 4 -
5. Pin Assignment
5.1. 12-pin Multi-connector (DC-IN/Trigger)
Type: HR10A-10R-12PB-01(Hirose) male.
(Seen from rear of camera.)
Pin no.
Signal
Remarks
1
GND
2
+12 V DC input
3
GND
4
Video output
Parallel with the BNC video output. Avoid
double termination.
5
GND
6
HD in
/out/Trig in
Trigger in for H reset trigger
HD in for H non-reset trigger. *1)
7
VD in
/out/WEN out/Trig in
Triggger in for H non-reset. *1)
8
GND
9
NC
/PCK/WEN
Pixel clk JP7 S. WEN JP18 S. *1)
10
GND
11
+12 V DC input
12
GND
3
4
5
6
7
8
9
10
11
12
1
2
Notes:
Factory settings in
bold italic
*1)
Signals on pin no. 6, 7 and 9 can be changed by jumper setting.
See “7.2. Jumper Settings” for more information.
Warning! Do not input signals not used for the actual mode!
Fig. 2. 12-pin connector.
5.2. 6-pin Multi-connector (RS 232C/TRIGGER)
Type: HR10A-7R-6PB (Hirose) male.
(Seen from camera rear.)
Pin no.
Signal
Remarks
1
TXD out
2
RXD in
3
GND
4
NC
5
Ext. Trig input
JP 5 short
for H reset. JP 20 for H non-reset. *1)
6
WEN out
/NC
*1) *2)
Notes:
Factory settings in
bold italic
*1)
Signals on pin no. 5 and 6 can be changed by jumper setting.
*2)
WEN is 1 H long and positive going. Negative if JP22 is Short.
See “7.2. Jumper Settings” for more information.
Warning! Do not input signals not used for the actual mode!
1
2
3
4
5
6
Fig. 3. 6-pin connector