.9.
GB
Installation
Positioning the Appliance
Positioning the appliance in the desired location. The back should
rest against the wall behind it, and the sides, along the adjacent
cabinets or wall. The dishwasher is equipped with water supply
and drain hoses that can be positioned to the right or the left to
facilitate proper installation.
Levelling the Appliance
Once the appliance is positioned, adjust the feet (screwing them
in or out) to adjust the dishwasher, making it level. In any case,
the appliance should not be inclined more than 2˚. If the appli-
ance is level, it will help ensure proper performance.
Cold Water Connection
Connect the cold water supply hose to a threaded 3/4 (gas)
connector, making sure that it is fastened tightly in place (see fig.1).
If the water pipes are new or have not been used for an extended
period of time, let the water run to make sure that the water is
clear and free of impurities. If this precaution is not taken, there
is a risk that the water inlet can get blocked and damage the
appliance.
Hot Water Connection
The water supply to the appliance can also be connected to the
house's hot water line (centralised system, heating system), as
long as it does not exceed a temperature of 60
.
In this case, the wash cycle time will be shortened by about 15
minutes and the wash efficiency slightly reduced.
The connection must be made to the hot water line following the
same procedures as those for the connection to the cold water
line.
Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter
of 4cm, Or let it run into the sink, making sure to avoid bending
or crimping it. Use the special plastic support that comes with
the appliance (see fig.2). The free end of the hose must be at a
height between 40 and 100 cm and must not be immersed in
water.
Attention:
The special plastic hose support must be solidly fastened to the
wall to prevent the drain hose from moving and allowing water to
spill outside the drain.
Use the new hose and the old hose should not be reused.
Electrical Connection
After making sure that the voltage and frequency values for the
current in the home correspond to those on the rating plate
(located on the stainless steel inner door of the appliance) and
that the electrical system is correct for the maximum voltage on
the rating plate, insert the plug into an electrical socket which is
earthed properly (the earthing of the appliance is a safety re-
quirement mandated by law).
Caution:
The dishwasher electrical plug must be accessible even when
the appliance is installed as a built-in unit so that maintenance
can be done safety.
fig.1
fig.2
Installation
Power switch
Wiring box
Door switch
Power indicator
switch
agent
missing
Rinsing
Overflow
switch
Dispenser
Washing
valve
Washing
pump
Water level switch
Drain
pump
Temperature limiter
Inlet
valve
Temperature limiter
Heater
1
2(1)
240V
~
50HZ
N
L
IG
3(1)
4(2)
F
IS
LS
1(2)
CnL1
4
3
2
8
7
6
5
1
4
CnP3
1
5
6
3
2
4
CnP1
6
5
8
7
11
CnP2
12
9
7
5
6
8
10
3
2
1
4
2
3
1
Temperature
Sensor
RELE’
1
3
1
2
L
D-ED
1/2
1
3
M
IAQS
2
ML
S
control panel
Relay
C
Diagram
Summary of Contents for IDI6IE2
Page 1: ......
