11
Install 5/16-18 x .75 square head bolts (item B),
5/16 flat washer (item C), and 5/16-18 hex head
keps nuts (item D) to the monitor bracket(item 2) .
Do not tighten this hardware.
Install the Monitor bracket by installing
the square head bolts (item 2) into the
milled slots in the front nut channels of
the upright. Gently slide the monitor
bracket (item 2) to the desired height
and tighten the hex head keps nuts to
hold them in place. Do not tighten this
hardware to more than 10 foot lbs of
torque. Doing so will cause scoring to
the aluminum of the upright.
If your monitor has a 100MM
mounting hole pattern (about 3.94")
attach the adapter plate (item A) to
the pivot (item 1) using the #10 hex
nuts and washers (items E and F).
If the mounting hole pattern of your monitor is 75MM (about 2.95") skip the previous step. Place
the nylon washer over the shaft of the pivot, and fit the shaft into the bronze bushing in the monitor
bracket
NOTE:
Your monitor can be installed to the pivot assembly prior to or after installing the pivot assembly to
the monitor bracket.
Installation
SMS FPD Mounting Front UPR MTD
