4
TOOLS NEEDED
:
Power or hand held Phillips head screwdriver with #2 tip, 7/16" and 1/2" combination
wrench or thin wall sockets.
QV-All American Series
Document Holder SPM Assembly
Step 1
- First, place the AMS FPD SPM FRT (square slots) BEHIND the AMS FPD SPM REAR bracket,
thread the Bolt, 1/4-20x.750 Carriage through the brackets and also the swing arm mount. Once the bolt is
threaded through use the Knob, Tri-Wheel 1/4-20 insert and 1/4 washer to connect the swing arm mount to
the brackets. Make sure the hardware is fully tightened and secure. You may now clip the bracket/Swing arm
assembly onto the slotted posts.
Step 2
-. Now, Place the Document holder pan onto the mounting arm where shown below and connect the
two using the Nuts, #10-32 Hex Keps BLK and Washers #10. Once the document pan is on the swing arm
mount, place Nut, Well #8-32 Neoprene onto the back of the document holder and line up the nuts with the
holes on the top of the Document holder, take the Clip, Document Holder Clipboard and thread the Screw, 8-
32 X .750 PPH MS through the clip, through the holes in the document holder, and finally through the
neoprene nuts on the back of the document holder. Make sure all hardware is fully tightened and secure.
