5
STEP 3
: The location of the bottom of the cylinder supp
ort brackets for a 30” worksurface starting
height is 7.5” from the floor. If your starting height is more or less than 30” add or subtract the
difference in starting height to or from 7.5” to locate the cylinder support brackets on the uprights.
EXAMPLE: for a worksurface starting height of 28" subtract 2" from 7.5" and set the brackets at
5.5
” from the floor. Attach the cylinder support brackets shown in Figure 3 item #2, to the uprights
using 5/16-18 x .75 square head bolts, 1/4 flat washers, and 5/16 hex keps nuts and tighten the
nuts. DO NOT OVER TIGHTEN.
Figure 3
STEP 4:
Remove the extruded guide assemblies, item 3 shown in Figure 3, from the worksurface
support
assemblies’ item 1 shown in Figure 1 on page 3. Attach the extruded guide assemblies to
the uprights using 5/16-18 square head bolts, 1/4 flat washers, and 5/16-18 keps nuts. Slide the
guide assembly down to the top of the cylinder support bracket and tighten the nuts. DO NOT
OVER TIGHTEN.
STEP 5
: To attach the worksurface support assemblies item 1 of Figure 4
position the motor
housing assembly between the bench uprights in front of the modesty panel. Plug the power cord
of the motor housing assembly into a 115 VAC power source. Using the motor switch turn the
motor system on in the UP direction so that the
cylinder shafts extends approximately 8” out of
the cylinder housing. Being careful not to damage the hydraulic lines carefully align the