The external power source is plugged in through jack item 3. Polarity of power jack is shown in Figure 3.
Figure 3 – Polarity of jack for external power source.
INTENDED USE
2.1
Operating restrictions
2.1.1
Working device cannot be placed closer than 2.5 m distance from a person.
WARNING!
Do not hold the device at a short distance next to a person's ears, as it can lead to
headaches and temporary hearing loss.
2.2
Device usage.
2.2.1
Press the power button item 2 (Figure 2) to turn on the device. Immediately after turning on the LED
starts to flash (item 6), and the device begins to emit ultrasonic waves.
2.2.2
For resulting expelling effect, it is important to choose the right place for the device. Please consider
the following factors:
- Ultrasonic waves reflect from solid materials and are absorbed by soft materials
- Ultrasonic waves do not pass through walls or partitions
- Maximum effective device functioning is obtained by placing it at a distance of 60-70 cm from the ground
(floor).
2.2.3
The result of device usage in closed space - a complete disappearance of pests is observed after 14
of continuous operating.
2.2.4
When using the device to expel rodents in gardens, it is recommended to seal it into a plastic bag and
place directly into the rodent hole or heel in at 10 cm depth. In order to expel moles place the device sealed into
plastic bag into a hole that was dug by a mole.
3
MAINTENANCE.
3.1
Maintenance requires only replacing of batteries as well as cleaning the surface of the device.
3.2
Current repair. Troubleshooting
Typical problems and possible solutions are specified in Table 2.
Таблица 2
Problem
Possible reasons
Possible solution
When you turn on the device the LED
does not lit.
Batteries are dead
Replace batteries
Batteries are not properly
installed
Install batteries in accordance with
polarity
Device is defective
Take the device to service center
