11
Appearance
#34*5(#"
Affix the instruction label to the desired
location, knock in 3 plastic anchors after
hole drilling and then lock in 3 self-tapping
screws to fasten the camera.
If it would be installed on the metal pil-
lar without grounding out, please use the
rubber pad enclosed for isolation. (You
could select to use enclosed washer for
better isolation.)
#34.*#3#*"
Loosen the two screws (left and right)
rst (just rotate slightly one circle or the
screws will fall down), second, rotate the
Retaining ring then you will be able to hold
the camera and adjust its angle. Fasten
the screws and retaining ring to ensure
the desired angle.
Vandal Proof IR Bullet Camera
INSTRUCTION MANUAL
#3 4)##
Loosen the screws (just rotate the screws
by one turn) to slide and adjust the lens
leftward and rightward directly. After
adjustment, be sure to lock them tightly
for waterproof.
#344)#v&8"k&B1C
It can be adjusted once the screw is fully
loosened. After adjustment, be sure to
lock it tightly for waterproof. (DC LEVEL
a n d F l i c ke r l e s s a d j u s t m e n t s a r e n o
function for DC12V model)
#"4 P b "* w )#g /
W :F # ; g # #
#3'4)##
Loosen the screws (one circle), then move
the sunshield hood forward and backward
to adjust the angle of sunshade. Be sure
to adjust the sunshield hood in coordina-
tion with lens in case of sunshade prob-
lems.
Partial enlargement view
Screw on the left and right
Retaining ring
SPECIFICATION
Image System
Image pickup sensor
1/3”-SONY CCD
Effective pixels(HxV)
NTSC HI:768 x 494
PAL HI:752 x 582
Electrical
Scanning system
NTSC: 2:1
interlace, V:59.94Hz,H:15.734KHz.
PAL: 2:1
interlace,V:50Hz,H:15.625KHz
Sync system
Internal
Lens
DC12V model:
f=3~9mm, F1.4 DC iris varifocal
lens
DC12V/AC24V model:
f=3.3~12mm, F1.4 DC iris
varifocal lens
Horizontal resolution
540TVL
Minimum illumination
0.3 lux (F1.4,50 IRE)
0 lux(When IR LEDs are on)
S/N ratio
More than 50dB
AES(Auto electronic shutter)
NTSC: 1/60 ~1/100000sec
PAL : 1/50 ~1/100000sec
Gain control
Auto
BLC(Backlight compensation)
On/Off
White balance
ATW (Auto trace white balance)
Flickerless On/Off
Video output
1Vpp composite output 75ohm
Power Supply
Power requirement
DC12V ± 10% (general)
DC12V / AC24V ± 10% (ICR D/N)
Power consumption
5.5 / 8W (Max) (ICR D/N)
Enviroment
Operating temperature
Operating humidity
30% ~ 90%
Storage temperature
Mechanical
Dimensions
85 (Ø) x 200 (H)mm
Weight
650g approx (with bracket)
