13
Rev. 161107
i3-TRNG-CAMS-Ax45RM_65RM-UM.indd
8. (For all outdoor surface installations).
Remove the protective film from the
black rubber gasket and adhere to the
base of the camera’s back box being
careful to match the holes on the gasket
with the holes/dimples on the back box.
9. Use a Phillips screwdriver to secure the
back box to the mounting surface with
self-tapping screws. If suitable for your
installation environment, use supplied
self-tapping screws with the built-in
O-ring.
Rubber
gasket. Use
in all outdoor
surface
installations.
Install the Camera:
10. Insert the microSD card into the microSD slot
on the camera module (if using).
11. Route the camera cabling according to
installation requirements through the selected
conduit (side or top) and connect to the camera,
including RJ45 PoE/Network cable, AC 24V
cable (if using), alarm and audio cables (if
using). Do not apply power until the installation
is complete.
12. Re-attach the camera to the mounted back box.
Use a Phillips screwdriver to re-tighten three
silver screws attaching camera to the back box.
13. Adjust the lens angle by rotating and panning
the camera lens base. Lift off the camera liner
for easy lens position adjustment. Do not over-
rotate the camera lens beyond the stop point to
avoid damage to the camera.
14. Once the desired view is achieved, replace
camera liner until it snaps back into place.
Complete the Installation:
15. Replace the camera’s dome bubble on top of the
camera module. Use the red dots on both modules for
easy alignment.
16. Use the supplied Torx bit to re-tighten 3 silver screws
securing the dome bubble housing to the camera
module. Remember to use sealant to maintain IP67
rating in outdoor installations.
