I-Tech NV115162, User Manual

Page: 28 / 30

7. If you forget the
“
password
”
of the switch (default is 00000000), please
contact your supplier.
8. CAT.5 Console Receiver power LED is not ON, to make sure power
adapter is connected to KVM CAT.5 receiver.
9. No video signal is displayed on the remote monitor.
●
Please check all VGA cables & connecters whether CAT.5 cable & connector is
loosed or disconnected. Also, please make sure VGA cable was attached to
computer during boot up process.
●
Power adapter is not connected to receiver.
10. Video signal is foggy or un-cleared on the screen.
Please check VGA connector, or the VGA resolution is too high for the length of cable
being used. If the problem happened at VGA resolution, to shorten the CAT.5 cable
length or reduce VGA resolution. It is highly recommended to use
“
optimal CAT.5 cable
length
“
to get the best video quality and don
’
t waste unnecessary CAT5 cable. High VGA
resolution is up to 1,280 x 1,024 and CAT.5 cable length could up to 500 feet
approximately.
13. FAQ
Rev. : 1.0 P.27