6
INSTALLATION AND OPERATION
Point-to-Point Operation
The extender can be operated in standalone mode, with a single receiver connected
directly to the transmitter. In this configuration, the two included AC power adapters
must be used because there is no power source for the Power over Ethernet (PoE)
feature. Perform the following steps to connect the
MN-H-C5-8211
system for point-
to-point operation:
1. Place or mount the transmitter and receiver in their desired locations.
2. Using a High Speed HDMI® Cable (not included), plug one end into the HDMI
input on your television, then plug the other end into the HDMI Output (2) on
the receiver.
3.
Plug the included IR Receiver into the IR In (3) jack on the receiver, then position
the IR receiver bulb in a position so that it can receive IR signals from your
remote control.
4. Using a High Speed HDMI Cable (not included), plug one end into the HDMI
Input (2) on the transmitter, then plug the other end into the HDMI output of
your video source device.
5.
Plug the included IR Transmitter into the IR Out (3) jack on the transmitter, then
position the IR emitter bulb in a position where it can transmit IR signals to the
video source device.
6.
Using an Ethernet cable wired to the TIA/EIA-568B standard, plug one end into
the
MN-H-C5-8211
RX (6) jack on the receiver, then plug the other end into
the
MN-H-C5-8211
TX (6) jack on the transmitter.
