11
on one of the AC power adapters into the DC 5V (4) jack on the receiver, then
plug the adapter into a nearby AC power outlet. The Power LED (5) on the
receiver front panel will illuminate. Repeat for each receiver as needed or
desired.
10. Using the AC power adapter that came with your Ethernet switches (not
included), plug the DC barrel connector into the power input jacks, then plug the
other end into a nearby AC power outlets.
11. If you are not using an Ethernet switch with PoE support or if you want to power
the transmitter using the included AC power adapter, plug the DC barrel
connector on the other AC power adapter into the DC 5V (4) jack on the
transmitter, then plug the adapter into a nearby AC power outlet. The Power LED
(5) on the transmitter front panel will illuminate. At the same time the Data
Transmission LED (7) on both the transmitter and receiver front panel will start
flashing slowly to indicate that a connection is being established. Once the
connection is completed, the Connection LED (8) on each unit will illuminate.
12. Start playing video content on your video source device. As data is being
transmitted, the Data Transmission LED (2) on each device will start flashing
rapidly, indicating that data is being transmitted and received. Verify that video
is being displayed on your remote televisions.
13.
Use your video source device's remote control at the remote televisions to verify
that you can control the video source device from the remote locations.
Congratulations, your
MN-H-C5-8211
system is now installed and ready for
use!
