30 www.i-sens.com
www.i-sens.com 31
It is recommended to place the test strip vertically into the
blood sample site as shown below.
Note:
The meter may switch off if the blood sample is not applied
within 2 minutes of the
symbol appearing on the
screen. If the meter turns off, remove the strip and reinsert it,
and start from Step 7.
Step 9
After the
symbol appears on the screen, apply the
blood sample to the narrow end of the test strip till the meter
beeps. If the confirmation window is not filled in time because
of abnormal viscosity (thickness and stickiness) or insufficient
volume, the Er4 message may appear.
Test result
Step 10
At this time, the display segments will rotate clockwise while the
blood is going in.
Test result will appear after the meter counts down from 5 to 1.
The result will be automatically stored in the meter’s memory.
If the test strip is removed after the test result is displayed, the
meter will automatically switch off after 3 seconds. Discard used
test strips safely in disposable containers.
Caution:
Do not allow any foreign substances, such as dirt, blood, or
water, enter into the meter. The meter may be damaged or
may malfunction. Follow the warning information provided
below to prevent possible damage to the meter.
• Do not apply the blood sample directly to the test strip port.
• Do not apply the blood sample to the test strip while
holding the meter in a way that the tip of the test strip faces
upwards. The blood sample may run down the surface of
the test strip and flow into the test strip port.
• Do not store your meter in unsanitary or contaminated sites.