i-onyx VN-855, Installation & Operation Manual

Page: 22 / 37

XX181-02-00 Rev 1107 VN-855 Ver 3 IP Camera
16
Configuring ViconNet (IP/LAN)
The VN-855IP camera is shipped with a ViconNet version 3 CD that contains the ViconNet version 3
software needed to setup your IP system, including the application setup, the camera firmware and setup
software (VNSetup). Be sure the ViconNet Workstation meets the minimum requirements, is running the
ViconNet application (version 3) (VNSetup) and has the proper PTZ camera driver. The VNSetup is found on
the included CD under software, IP Camera Setup. Refer to appropriate ViconNet documentation.
The default parameters on the IP camera are:
IP address: [10.10.10.1].
Nucleus IP address: [1.1.1.1].
On first startup, the camera will attempt to establish connection to the Nucleus with the default address
(1.1.1.1). Connecting it to an active Nucleus is done through the VNSetup utility.
Note: When connecting to ViconNet application version 3, the number of concurrent users viewing video
from the same device cannot exceed 10 users.
Groups and Users Restrictions
ViconNet allows creating Multiple Groups and Users in order to limit the rights to different levels. For more
information on how to create Users and Groups, refer to the latest revision of ViconNet manual XX113.
Although the ViconNet software does not limit the number of Groups and Users that can be created, the
VN-855IP IP Camera has Users and Groups limitations. For ViconNet version 3, the camera can support the
first 20 Groups (including Administrators and Guests) and the first 100 Users.