i-onik BTH-033, Quick Start Manual

Page: 17 / 20

32 33
- If you want to remotely select the last/next song, or pause/
play, it needs your Bluetooth mobile phone or Bluetooth
transmitter need to be paired with the headset to support
the AVRCP profile. Refer to the user’s manual of your mobile
phone or Bluetooth transmitter for further information.
- The Bluetooth will disconnect the headset and the mobile
phone automatically if you plug in 3.5 mm audio input, and
the line in is available at the time.
6. LED Indicator
1) Charging
7. Indication Tone
8. Factory Reset
In the status of turned off, long press MFB and pause buttons
for 8 seconds simultaneously and don’t release them until the
red and blue LED indicators are on.
9. Resetting
If the product works abnormally, you can plug a 3.5 mm Line-in
or charge the headset so that it resets the product.
Care and Maintenance
Read the recommendations below carefully before using the
“BTH-033”. By following these you will be able to enjoy this
product for many years.
- Keep it dry and don’t put it in a dump place, to avoid the
product’s internal circuit being affected.
- Keep the product away from direct sunlight or hot places.
High temperatures will shorten the life of electronic devices,
destroy the battery or distort certain plastic parts.
- Don’t expose the product to cold areas. It may damage the
internal circuit board.
- Don’t try to disassemble the product as it may get damaged.
- Don’t let it fall down on to the floor or on other hard surfaces.
The internal circuit might get damaged.
2) Pairing with Bluetooth Device
LED indicator Status of headset
Red LED on Charging
Red LED off Finished charging
LED indicator Status of headset
Red and blue LED indicator
flashes alternately
Pairing mode
Blue LED indicator flashes
once quickly every 2 seconds
Not connected device
Blue LED indicator flashes
twice quickly every 4 seconds
Have already connected HFP
or A2DP
Blue LED indicator flashes
three times quickly every
4 seconds
Connect HFP and A2DP
simultaneously
Blue LED indicator flashes
quickly
Calling/incoming call
Blue LED indicator flashes
once quickly every 4 seconds
During a call
Indication tone Status of the headset
Continuous two prompt tone
every 10 seconds
Conversation mode and
microphone mute
Three ‘dong’ warning sounds
every 30 seconds
Low battery
Blue LED indicator flashes
once quickly every 4 seconds
Low battery