page 23
2.6.8. Firmware Flash
This panel is used to update the firmware of the OABR switch. The firmware will
exclusively delivered by i-novative GmbH as i-nvoative firmware file (.iff). After
Installing the GUI, the associated Flash software is also in the program folder: \ Firmware \.
To enable upload, the target system and the bootloader version in the loaded file and the attached
hardware must match together. After starting the flash process, the switch performs a reset and
the firmware is flashed. If the switch can not perform an automatic reset, the reset switch on the
switch must be pressed for 5 seconds (point 2.), until the firmware is loaded.
Note:
Flashing the device resets or overwrites all OABR switch configurations to their default
values.
Please save all configuration settings via the GUI in a file (XML Config) before the
firmware flash.
1. Loading the firmware file:
Please select the location of the
Firmware file with „
Browse
“...
2. Reset switch:
In case of no automatic reset, the
reset switch must be pressed for
at least 5 seconds to start update
process.
3. Flash process
The device starts with the upload of
the firmware. Please wait until the
flash process ended correctly and
was confirmed by the GUI.
NOTE:
Installing the firmware
must not be interrupted as this
can lead to an inconsistent
condition of the device.
Summary of Contents for 2-Port OABR Multi-Media-Switch
Page 27: ...page 27 ...
