EMS i-MO 200-S Series Hardware Installation Guide
Version
2.0
ELECTRONIC MEDIA SERVICES LIMITED
PASSFIELD BUSINESS CENTRE, LYNCHBOROUGH ROAD, LIPHOOK, HAMPSHIRE, GU30 7SB, UK
Tel:
01428 751655 |
Fax:
01428 751654 |
E-mail:
Page
7
of
20
Hardware Installation Guide
The i-MO appliance is supplied un-configured unless otherwise agreed with your supplier. Please confirm the
specification of the unit with your supplier as not all features are supported on every unit. This guide
describes how to connect and get started with the device. Electronic copies of this guide can be found by
clicking this link:
or by entering this URL: http://tinyurl.com/lt297hl
1) How to open the appliance (optional)
Step 1
- Ensure the appliance is switched off and the power cable is removed.
Gently remove all aerials if connected.
Step 2
- Place the unit on a clean, soft surface that will not scratch the case.
Gently
undo the 4 screws at
the rear of the unit as shown below in images
1
,
2
and
3
.
Step 3
- Gently slide the back panel towards you as shown in images
4
and
5
above. Continue to slide the
panel out of the case as shown in image
6
above. Lay the printed circuit board flat with the modem board
facing upwards, as shown in image
7
above.
2) How to install Modems (optional if not already fitted)
The two modem slots are outlined in red as shown in image
1
below. The unit can be fitted with one or two
modems as required. For a single modem please use
Modem A
position and
Modem Aerial connector A
,
as shown in image 1 above.
Step 1
- Undo the top nuts only, of the Modem mounting bolts, using a 5mm spanner as shown in image
2
and
3
below. Do
not
undo the bottom nuts.
