I-GO S20, Owner'S Manual

Page: 8 / 80

8
i-Go™
E
N
Hi-Low Switch
This switch toggles the scooter’s speed between Hi and Low.
Toggle the switch forward (Hi) to achieve the maximum
preprogrammed speed for the scooter. Toggle the switch
rearward (Low) to achieve half the maximum preprogrammed
speed of the scooter.
Battery Condition Meter
When the key switch is engaged to power up your scooter,
this meter indicates the approximate battery voltage strength
on your tiller display. For further information on battery
charging, see III. “Batteries and Charging.”
Drivetrain Assembly
The drivetrain assembly is an electromechanical unit that
converts electrical energy from your scooter’s batteries into the
controlled mechanical energy that drives the scooter’s wheels.
Battery Pack
Your scooter is equipped with an innovative easy-to-remove
Lithium-Ion battery pack. Refer to III. “Batteries and
Charging” for battery pack replacement instructions. See
fi gures 2 and 3.
Main Circuit Breaker (Reset Button)
When the voltage in your scooter’s batteries becomes low or
the scooter is heavily strained because of excessive loads or
steep inclines, the main circuit breaker may trip to protect the
motor and electronics from damage. See fi gure 3.
 The main circuit breaker reset button pops out when the
breaker trips.
 When the breaker trips, the entire electrical system of
your scooter shuts down.
 Turn key switch off .

Allow a minute or two for your scooter’s electronics to
“rest.”
 Push in the reset button towards the rear of the scooter to
reset the main circuit breaker.

If the main circuit breaker trips frequently, you may need
to charge your batteries more often.

If the main circuit breaker trips repeatedly, see your
authorized Dealer for service.
I I . YO U R S C O O T E R
Figure 2. Battery Pack
IDENTIFICATION KEY
1. XLR Connector
2. Battery Connector
3. LED Charge Display Button
4. LED Charge Dislpay
IDENTIFICATION KEY
1. Circuit Breaker
2. Battery Pack
3. XLR Port
Figure 3. Main Circuit Breaker