HYVA AMCO VEBA NG Series, User Manual

Page: 16 / 24

USER MANUAL
C
ONTROL
P
LATFORM
U
SE
B.10
7845429-00 09/17
subject to change without notice
B.7 OPERATING THE CRANE FROM PLATFORM
The use of a crane with platform requires to pay close attention because the control stations and the
stabilizer control levers are located in positions different from the standard ones.
B.7.1 HOW TO ENTER AND LEAVE THE PLATFORM
Procedure to open and enter the platform:
1) Disengage the ladder locking device, and put it in the holder (see B.5.1).
2) Pull the ladder handle and extract completely the folded ladder.
3) Carefully incline downwards the ladder and unfold it.
4) Climb the stairs grasping strongly the platform's frame.
5) Raise the locking gate and open the tiltable protection bar.
6) Enter the platform and lock the safety gate.
Procedure to leave and close the platform:
1) Unlock the safety gate and rotate it downwards.
2) Exit the platform and stay on its edge grasping strongly the platform's frame
3) Incline the protection bar into the closed position.
4) Lock the bar with the locking gate.
5) Go down the ladder.
6) Fold the ladder and raise it up to the closing position
7) Engage the ladder locking device.
B.7.2 HOW TO DEPLOY THE STABILIZERS
1) Unlock and extract the stabilizer extension on the platform side.
2) Unlock and extract the stabilizer extension on the opposite platform side.
3) Staying on the same side, extend all stabilizer legs and place them on the ground.
4) Unfold the boom until you can open the platform (see B.7.1).
5) Enter the platform and complete the stabilization with the suitable stabilizer controls.
For other information refer to the User Manual.
B.7.3 HOW TO FOLD THE STABILIZERS AND THE CRANE
Carry out the following procedure using only the auxiliary controls on crane's base.
1) Staying on the opposite platform side, retract fully all stabilizer legs.
2) Retract fully the stabilizer extension on opposite platform side.
3) Retract fully the stabilizer extension on platform side.
4) Fold the crane using the auxiliary controls.
For further information refer to the User Manual.