Hyundai WS 1855, Instruction Manual

Page: 29 / 52

EN - 29
EN
Indoor Humidity display and Comfort Icon
• Indoor Humidity display on A6
• Comfort Icon display on A5.
“Dry” indicate the indoor humidity < 40%
“Comfort” indicate the indoor humidity is between 40% and 70%,
the indoor temperature is between 20°C and 26°C
“Wet” indicate the indoor humidity ≥ 70%
Thermometer:
• Press “- (°C/°F)” button (B3) to select Indoor/Outdoor Temperature in Celsius mode/
Fahrenheit mode.
• If the temperature is out of the measurable range, LL.L ( beyond the minimum temperature)
or HH.H (beyond the maximum temperature) will be shown on the LCD.
The use of 1.5m cord Temperature Probe:
• Insert the probe plug (D8) on the right hand side of the Thermo Sensor Unit.
• Put the metal casing outside and leave the Thermo Sensor Unit in an indoor area to avoid
freezing up the battery when the outdoor temperature is below -20 °C.
• Always use the temperature probe to sense the temperature when the temperature is
between the following range: -50°C ~ 0°C and + 50°C ~ + 70°C
Radio Controlled Clock:
• After registered new channels (Outdoor temperature) or press “RF SEARCH” button (B7) to
stop scanning, the clock will then scan the DCF time signal ( flashes on the LCD). Buttons
will not function while scanning for DCF or Thermo sensor’s signal unless they are well
received or stopped manually.
• The clock automatically scans the time signal at 3.00 a.m. everyday to maintain accurate
timing. For failed reception, scanning stops ( on the LCD disappear) and repeats again
at 4.00 a.m. 5.00 a.m. and 6.00 a.m.
• The clock manually scans the DCF time signal by holding “RECEIVE ” button (B3)
for 3 seconds. For failed reception, scanning stops ( on the LCD disappear).
• Hold the “RECEIVE” button (B3) to stop scanning when receiving DCF time signal.
flashes indicate now is receiving DCF time signal
turns on indicate signal received successfully.
• “ DST ” is shown on the LCD if it is in Daylight Saving Time mode