![background image](http://html.mh-extra.com/html/hyundai/rt190surip/rt190surip_instruction-manual_2195088032.webp)
EN - 32
LISTENING TO RADIO
Manual tuning
1. Turn on the Power (16) and select Function knob (5) to “Tuner” position.
2. Select the desired band by Radio Band Selector(2)
3. Tune to the required station by turning the Tuning Knob (18).
4. Adjust the Volume Knob (16) to desired volume level.
FM & FM-stereo reception
●
Set the Radio Band Selector (2) at “FM” position, program are received in Mono mode. In
particular when stereo signal are weak. It is preferable to receive the program in Mono.
●
Set the Radio Band Selector (2) at FM-ST” position for receiving stereo programs. The FM-
Stereo LED Indicator (6) will light up to show FM Stereo program is receiving.
Hints for best reception:-
- AM : The receiver has a built-in bar antenna. If AM reception is weak. Slight rotate or re-
positioning of the unit will usually improve the AM reception.
- FM : The receiver has a built-in FM Wire Antenna (25) hanging at the rear cabinet. This wire
should be totally unraveled and extended for best reception.
LISTENING TO PHONO
NOTED:
- Remove the stylus protector.
- Be sure that the tone arm is being detached from the tone arm
rest before operating and re-secured again after wards.
1. Select to “Phono” function from Function Selector(5)
2. Set the speed selector to the proper position depending on the
record to be played.
3. Place the record on the platter(use the Spindle Adaptor if
required).
4. Lift the tone arm from the rest and slowly move it to the record
side. The platter will start to rotate.
5. Place the tone arm to the desired position of the record.
6. Adjust the volume to the desired level.
7. At the end of the record, the platter will automatically stop rotating.
Lift the tone arm from the record and return to the rest.
8. To stop manually, lift the tone arm from the record and return it to
the rest.
REMARK:
As some kind of record the auto-stop area was out of the unit setting, so it will stop
before the last track finish. In this case, select the Auto-Stop Switch (22) to “Off” position. Then it
will run to the end of the record but will not stop automatically.(Turn off the unit by power button
or switch back the Auto-Stop Switch(22) to “On” position to stop the platter rotate). Then put
back the tone arm to the rest position.
Remark : Due to Aux and Phono were designed at the same position of this system. When Aux
in jack(24) plugged by 3.5mm plug. The channel will change to Aux automatically and turntable
will stop to rotate. Please ensure the Aux in jack (24) without plugged by anything before playing
Phono.