EN
EN - 35
Removing of USB
To remove the USB, turn off the power or switch the function mode to tuner first.
For USB port – un-plug it by pulling out the USB socket directly.
PHONO
NOTED:
- Remove the stylus protector.
- Be sure that the tone arm is being detached from the tone arm
rest before operating and re-secured again after wards.
1. Select to “Phono” function from Function Selector(7)
2. Set the speed selector to the proper position depending on the
record to be played.
3. Place the record on the platter(use the Spindle Adaptor if
required).
4. Lift the tone arm from the rest and slowly move it to the record
side. The platter will start to rotate.
5. Place the tone arm to the desired position of the record.
6. Adjust the volume to the desired level.
7. At the end of the record, the platter will automatically stop rotating.
Lift the tone arm from the record and return to the rest.
8. To stop manually, lift the tone arm from the record and return it to the rest.
REMARK:
As some kind of record the auto-stop area was out of the unit setting, so it will stop
before the last track finish. In this case, select the Auto-Stop Switch (28) to “Off” position. Then it
will run to the end of the record but will not stop automatically.(Turn off the unit by power button
or switch back the Auto-Stop Switch (28) to “On” position to stop the platter rotate). Then put
back the tone arm to the rest position.
LINE OUT CONNECTION
You can connect the system to your whole Hi-Fi system by connecting the Line Out Socket (26)
to the auxiliary input socket with a RCA cable (not included).
Remark: Due to ErP stage two requirement and protect the environment. The unit will
switch to standby mode automatically once no any music playing over 15 minutes.
