8. STORING THE MACHINE
If you do not follow these steps, deposit may arise in the
carburetor.
This will cause starting difficulties and may cause permanent
damage
8.1.
Perform all the general maintenance that the maintenance section of your ‘User
Manual’ is recommended.
8.2.
Clean the outside of the machine, drive axle, shield and nylon cutting head.
8.3.
Remove all fuel from the fuel tank.
8.4.
After all the fuel is drained, start the engine.
8.5.
Allow the engine to run in idle until engine stops alone. This allows the fuel to be
removed from the carburetor.
8.6.
Allow engine to cool down (about 5 minutes).
8.7.
Use a spark plug wrench, remove the spark plug.
8.8.
Pour 1 teaspoon of clean 2-cycle oil into the combustion chamber. Slowly pull
the starter rope several times to coat internal components. Replace the spark
plug.
8.9.
Store the machine in a cool, dry place away from any source of ignition such
as an oil burner, water heater etc.
8.10.
Transporting the machine.
8.10.1.
When transporting the machine make sure that no fuel is allowed to leak
out.
8.10.2.
DO NOT allow the trimmer
cutter come into contact with
persons, animals and property.
Page 20
Rev 2
Summary of Contents for HYWT5080
Page 1: ...WHEELED TRIMMER Model HYWT5080 User Manual...
Page 2: ...Page 2 Rev 2...