6.2.
Engine - Warm start.
6.2.1.
Fill the machine with fuel as described in section 5.
6.2.2.
Turn the power switch (1) to the on position (I).
6.2.3.
Set the machine on a firm and flat surface.
6.2.4.
Move the choke lever (5) to the lower (open)
position.
6.2.5.
Keeping the cutting head off the ground, pull the starter rope (4) with a short
stroke out until resistance is felt (about
100mm). Then pull firmly and continuously, do not let go of the starter handle
instead let it return slowly.
6.2.6.
Before starting work allow the engine to warm up at idle speed for about
ten minutes.
6.2.7.
If engine does not start then follow the Engine - Cold start section.
6.2.8.
Never leave the machine unattended.
6.3.
Stopping the machine.
6.3.1.
Release the throttle lever and let engine idle.
6.3.2.
Press the start-stop switch on the handle to off position (
O
) and wait until
the machine stops.
6.3.3.
Never leave the machine unattended.
6.4.
Trimming techniques.
If you are not familiar with the trimming, practice with the machine in a
safe place.
6.4.1.
Always trim or cut with high engine speeds.
Page 15
Rev 2
Summary of Contents for HYWT5080
Page 1: ...WHEELED TRIMMER Model HYWT5080 User Manual...
Page 2: ...Page 2 Rev 2...
