For inquiries please contact:
Licensed by HYUNDAI Corporation Holdings, Korea
E-mail: [email protected]
Imported/Distributed by Azoogi Pty Ltd
www.hyundailighting.com.au
Installation Steps
1. Before installation, make sure the power supply is switched off.
2. Attach the spike to the light via the screw provided.
3. Adjust the orientation of the garden light to the desired angle and tighten the screw.
4. Spread the connection cable in your garden placing the cable end with the male connector near the
power point.
5. Connect the garden lights to the cable via the provided connections. Make sure you align the notch
in the connectors before connecting them. Tighten the
connector cap to seal the connection and stake the light into the ground.
6. Connect the LED driver to the input cable of the smart controller and connect the output cable of
the smart controller to the garden light cable
7. If not all garden lights are used, seal the open connectors using the connector plugs provided.
8. Connect the 3-pin plug of the driver to the AC mains socket and switch the power supply on.
Note:
1. Make sure the LED driver, the smart controller and the garden light are not sited such that they get
flooded with water.
2. Ensure all connections are tight and sealed by tightening the connector cap.
3. Do not leave any connector open.
Wiring
Refer to the wiring diagram below for wiring illustrations.
2.5m
1
m
1
m
1.5m
