![background image](http://html1.mh-extra.com/html/hyundai/hych1500-2/hych1500-2_user-manual_2196088023.webp)
23
7.9
If the machine should start to make unusual noises or vibrations, immediately shut off
the engine, disconnect the spark plug HT leas and check for the cause.
Usually noise or variation is generally a warning of trouble.
You
MUST
find the source of the problem and fix it before reusing the machine.
7.10
Use only attachments and accessories approved by the manufacturer.
Failure to do so can result in personal injury and may invalidate any warranty.
7.11
Maintain the machine and check for misalignment or binding of moving parts, broken
parts and any other condition that may affect the machines operation.
If damaged have the machine repaired before reuse.
7.12
Keep the engine, exhaust and muffler free of grass, leaves, wood chips, excessive
grease or carbon build up to reduce the risk of fire.
7.13
NEVER
pour or squirt the unit with water or any other liquid.
Keep handles dry, clean and free from debris. Clean the machine after each use.
7.14
DO NOT
allow persons unfamiliar with the machine or these instructions to operate it.
This machine can be extremely dangerous in the hands of untrained users.
7.15
Thoroughly inspect the area to be worked, keep the working area clean and free of
debris to prevent tripping. Operate on flat level ground.
7.16
NEVER
place any part of your body where it could be in danger if movement should
occur during assembly, installation, operation, maintenance, repair or moving.
7.17
Keep all bystanders, children and pets at least 23m (75 feet) away.
If you are approached, stop the machine immediately.
7.18
The operator or user is responsible for preventing accidents or hazards occurring to
other people, their property and themselves.
7.19
Start the engine carefully according to instructions.
7.20
Before starting the wood chipper, make sure the feed hopper and cutting housing are
empty and free of all debris.
7.21
NEVER
place your hands, feet, or any part of your body in the chipper hopper,
discharge opening, or near or under any moving part while the machine is running.
Keep area of discharge clear of people, animals, buildings, glass, or anything else that
will obstruct clear discharge, causing injury or damage. Wind can also change discharge
direction, so be aware. If it becomes necessary to push materials to the chipper hopper,
use a small diameter stick, not your hands.
7.22
NEVER
allow an accumulation of processed material to build up in the discharge
hopper area as this will prevent proper discharge and can result in kickback from the
chipper hopper.
7.23
Keep your face and body back from the chipper hopper and discharge chute to avoid
accidental bounce back of any material.
7.24
NEVER
reach with your hands, into the the feed hopper past the rubber flap while
operating the machine.