12
assembly continued…
3.2
Pull the chain guard towards the front handle until you hear an audible click to
check the chain brake is disengaged (1).
3.3
Loosen the nuts and remove the chain sprocket cover (2).
3.4
Install the bumper spike to the power unit using the 2 screws provided in the
tool kit (3).
3.5
Install the guide bar over the 2 studs and whilst wearing thick protective gloves,
place the chain round the rear sprocket and the guide bar (4).
NOTE
Pay attention to the correct direction of the saw chain.
This is indicted on the guide bar.
3.6
Adjust the position of the chain tensioner stud on the chain cover moving it back
towards the lower adjustment hole on the guide bar. (5).
1
2
3
4
5
Summary of Contents for HYC6220
Page 31: ...31 NOTES...
Page 32: ...32...
