1.9. Additional safety labels.
Keep all children, bystanders and helpers 15
meters from the machine.
Warning against flying objects wear helmet,
goggles and ear protection.
Warning: Danger from hot components,
especially exhaust - Keep clear of combustible
materials.
1.10. Additional safety instructions.
1.10.1. Spectators should be told how to
correctly attract the operator’s attention,
otherwise it could create an unsafe situation.
1.10.2. Never touch either the nylon cutting
head or the metal cutting blade whilst the
machine is in use – You MUST allow the
machine to come to a stop and to remove the
HT lead before carrying out any maintenance.
1.10.3. During and after use the engine and
exhaust will be very HOT you must keep all
your all parts of your body and clothing
including all combustible materials clear of the
engine and exhaust.
1.10.4. DO NOT use the machine during or
after rain, snow or sleet. The floor will become
slippery. DO NOT use the machine on a slope
or uneven ground or if there is the chance of
slipping or losing the stability.
1.10.5. If you trip or fall whilst machine is in
use you MUST immediately release the
throttle, and turn off the ignition switch.
1.10.6. If you hit any obstacles you must stop
the machine and remove the HT lead so that
you can inspect the machine. IF the machine is
damaged in any way you MUST get it repaired
before restarting work.
1.10.7. DO NOT use the machine with a blunt,
cracked or damaged cutter blade.
1.10.8. When using the blade cutter there is a
danger of kickback. Kickback is a reaction that
can occur when the rotating cutting blade
strikes an object which cannot be cut. This
contact causes the cutting blade to stop for an
instant and then suddenly repel from the
object taken with accelerated force. This
reaction can be violent enough that the
operator momentary loses control of the
machine. A kickback can occur without
warning when the cutter encounters an
unseen obstacle when the blade is running.
This is more likely in areas where it is difficult
to properly check the material/area to be cut.
For easy and safe cutting, cut the weeds/brush
from right to your left.
1.10.9. If any trimmed materials get tangled in
the nylon cord or cutting blade you MUST stop
the machine and remove the HT lead. Onley
then can you clear any blockages.
1.10.10.
NEVER use the machine with a saw blade
attachment it is STRICTLY FORBIDDEN.
1.10.11.
DO not use the brush cutter
for trimming trees.
1.10.12.
DO NOT wear rings and
jewelry or loose, dangling clothing that could
get caught in the machine. DO NOT wear
footwear with unprotected toes and DO NOT
work barefoot or without leg protection. In
certain situations, you have to wear head
protection.
Page 7
Summary of Contents for HYBC5080AV
