Hyundai HYBC5080AV, User Manual

Page: 27 / 36

When sharpening the blade you MUST wear safety gloves.
6.3.1. Remove the cutting blade (2) from the shield (1).
6.3.2. Put cutting blade securely into a vice.
6.3.3. Sharpen the blade with a suitable flat file.
6.3.4. Please make sure that you maintain the angle of cutting. Maintain the original cutting angle.
6.4. Storage.
If you do not follow these steps, deposit may
arise in the carburetor. This will cause starting
difficulties and may cause permanent damage.
6.4.1. Perform all the general maintenance
that the maintenance section of your ‘User
Manual’ is recommended.
6.4.2. Clean the outside of the machine, drive
axle, shield and nylon cutting head.
6.4.3. Remove all fuel from the fuel tank.
6.4.4. After all the fuel is drained, start the
engine.
6.4.5. Allow the engine to run in idle until
engine stops alone. This allows the fuel to be
removed from the carburetor.
6.4.6. Allow engine to cool down (about 5
minutes).
6.4.7. Use a spark plug wrench, remove the
spark plug.
6.4.8. Pour 1 teaspoon of clean 2-cycle oil
into the combustion chamber. Slowly pull the
starter rope several times to coat internal
components. Replace the spark plug.
6.4.9. Store the machine in a cool, dry place
away from any source of ignition such as an oil
burner, water heater etc.
6.5. Transporting the machine.
6.5.1. When transporting the machine make
sure that no fuel is allowed to leak out.
6.5.2. DO NOT allow the trimmer/brush
cutter come into contact with persons, animals
and property.
6.3. Trimmer blade sharpening.
Page 27